ConvaTec ActiveLife 1-PC Pre-cut DRNBL Pouch W/1-SD Panel & Tail Clip 12in.L, 38mm STM, Transparent

The ConvaTec ActiveLife pouch comes pre-cut with a tail clip and one-sided comfort panel. It combines a skin barrier and a pouch into one system to keep stoma draining manageable. It is quiet and odor-proof, allowing you to wear it discreetly. The lightweight and flexible design keeps it comfortable while you are active. FSA Eligible
ActiveLife combines the skin barrier and the pouch into one simple, easy-to-manage system
Pouch allows for draining
Durahesive plus skin barrier comes with tape collar
1-sided comfort panel and tail clip included
Transparent, lightweight, flexible and convex design

See directions below.

See directions below. Preparation of skin barrier/wafer: Measure stoma size with the measuring guide provided. Trace exact stoma size onto the center white release paper of the skin barrier. The small starter hole should be in the center of your tracing.
For skin barriers with pre-cut stoma openings: Select a pouching system with a pre-cut stoma opening the same size as the largest diameter of the stoma. Do not enlarge the pre-cut stoma opening.
Important: Before cutting, separate front and back panels to avoid cutting through the pouch. Ensure inner surfaces of pouch are separated and that pouch contains a small amount of air. Cut along the tracing with curved, short-bladed scissors.
Cut center hole the same size as the stoma, using the guidelines on release paper. Do not cut beyond last line.
Remove white release paper from skin barrier. Leave outer release paper on tape collar in place.
Caulking material, such as Stomahesive paste, can be applied to back of skin barrier to further fill gaps between wafer and stoma. Allow paste to set for one min prior to application skin. (Do not spread paste.)
Place pouching system gently in position over stoma. Press skin barrier against the skin, paying particular attention to area closest to stoma.
During application, maintain gentle pressure on skin barrier for 30 sec to improve adhesion.
After skin barrier is in place, remove one side of release paper on tape collar and smooth onto skin, working from the center out to edges. Repeat with other side, making sure tape is smooth and wrinkle-free.
Important: Durahesive wafer will swell around stoma, resulting in a "turtlenecking" effect. This is normal and will not harm the stoma or prevent flow of urine and stool, even if stoma is completely covered.
Removal of skin barrier/wafer: Gently pull skin barrier down, away from skin, while supporting adjacent skin with your other hand.