Purify O3 Portable CPAP Sanitizer with Ozone Disinfector

Purify O3 is the simple & effective way to achieve hospital-grade disinfection for your PAP equipment and supplies! Purify O3 utilizes ozone (activated oxygen) technology - one of the most effective methods to sanitize the areas of PAP equipment that cleansing wipes and UV light cannot reach.Ozone is widely used in a number of industries worldwide, including medical facilities, public water purification, food process, and hoteloffice housekeeping industries.Simple To Use - One-Touch Controls: One button push-to-start initiates the disinfection process. The unit will shut off automatically when the cycle is complete.Quick Clean: Disinfection cycle lasts only 35 minutes, with an additional 9 minute recommended rest to allow residual ozone to dissipate.Maintenance Free: Liquid-free cleaning. No additional pre-wash solutions, replacement bags or extra filters required.Ultra Quiet: Ultra quiet sanitizing, with audible alerts when cycle is complete.FSAHSA EligibleDual purpose sanitizingtravel case included in kit.FDA Registered. Simple To Use, One-Touch Controls
Quick to Clean
Maintenance free

See the full list of product ingredients on the product label.

See directions below. Disconnect mask and tubing from CPAP/BiPAP machine
 Using a cleansing wipe or damp clean cloth, lightly surface clean mask/nasal pillow of any residue
 Connect the tubing to the Purify O3 unit and place mask, tubing and sanitizer inside the supplied sanitizing/travel case
If the tubing and mask assembly is too large for the sanitizing case, a medium-sized storage container with lid (less than 12 qts) may be used.  For mask-only sanitation, place mask and Purify O3 unit inside sanitizing case
Press and hold On/Off button for 3 seconds to turn on Purify O3 sanitizer.  The unit will beep once and the green light will illuminate to indicate the device is now active and in use. Ozone will begin streaming
Ensure the mask/tubing and Purify O3 are inside the sanitizing case or container.
Zip case fully closed (or secure container lid, if utilizing). The sanitizing cycle for Purify O3 is approximately 35 minutes in length.  When complete, the unit will beep 5 times and power off
After the cleaning cycle is finished, allow the unit to remain in the closed case/container for an additional 90 minutes to allow the residual ozone to dissipate
To stop the sanitation process mid-cycle, press and hold the On/Off button for 3 seconds.  The unit will signal the cancellation with a long beep and power off
Re-seal container.  Allow unit to sit in closed case/container for at least 90 minutes to allow ozone to dissipate
Repeat procedure for empty humidification chamber

Operate only in a well-ventilated area. Do not breathe or ingest the ozone. Do not use your CPAP/BiPAP equipment for at least 90 minutes after sanitation is complete to allow remaining ozone to dissipate. Ensure Purify O3 and all equipment to be disinfected is placed in the closed sanitizing bag or sealed container during the sanitation cycle.